TP-Link CPE210 - Typical Application Configuration


2. 7\SLFDO$SSOLFDWLRQ&RQƮJXUDWLRQ
The typical topology is as follows. A wireless bridge is built between two
locations that are far from each other. Follow the instructions below to
FRQƮJXUHWKH$FFHVV3RLQWDQG&OLHQW
Access Point Client
Computer
IP Camera
LAN: 192.168.0.254 LAN: 192.168.0.2
&RQƮJXUHWKH$FFHVV3RLQW$3
1. Log in to PharOS and go to the Quick Setup page.
 Operation Mode: Select Access Point and click Next.
3. LAN Settings: Click Next.
4. Wireless AP Settings:
D&UHDWHDQHZ66,'1HWZRUNQDPHIRU\RXUZLUHOHVVQHWZRUN
b. Select WPA-PSK/WPA2-PSK for the Security method and create
a PSK Password to protect your AP.
c. Enter the distance between the Access Point and the Client into
WKH'LVWDQFH6HWWLQJƮHOG
d. Select the 0$;WUHDPFKHFNER[5HIHUWR4LQ)$4IRUGHWDLOV
DERXW0$;WUHDPDQGFOLFNNext.
 Finish: Verify your settings and click Finish to complete the
FRQƮJXUDWLRQ
&RQƮJXUHWKH&OLHQW
1. Log in to PharOS and go to the Quick Setup page.
 Operation Mode: Select Client and click Next.