TP-Link Jetstream Series Guide

4
Lightning Protection
Figure 1 Connecting to the Ground via Power Supply
Device (Rear Panel)
AC Power Cord (with PE cable)
Note:
•
The figure is to illustrate the application and principle. The power plug you get from the package and
the socket in your situation will comply with the regulation in your country, so they may differ from
the figure above.
•
If you intend to connect the device to the ground via the PE (Protecting Earth) cable of AC power
cord, please make sure the PE (Protecting Earth) cable in the electrical outlet is well grounded in
advance.
Connecting to the Ground via the Grounding Terminal

Use the grounding bar
If the device is installed in the Equipment Room, where a grounding bar is available, you are
recommended to connect the device to the grounding bar as shown in the following figure.
Figure 2 Connecting to the Grounding Bar
Device (Rear Panel)
Ground Cable
Grounding Terminal
Grounding Bar
Note:
The grounding bar and the ground cable are not provided with our product. If needed, please self purchase
them.

TP-Link Jetstream Series Specifications

General

Model	Jetstream Series
Type	Multiple types exist within the Jetstream Series
Ports	Multiple port configurations exist within the Jetstream Series
Layer	Layer 2/Layer 3
PoE Support	Available on some models
Uplink Ports	Varies depending on the specific model
Switching Capacity	Varies depending on the specific model
Forwarding Rate	Varies depending on the specific model
MAC Address Table	Varies depending on the specific model
Packet Buffer	Varies depending on the specific model
Power Consumption	Varies depending on the specific model
Dimensions	Varies depending on the specific model
Weight	Varies depending on the specific model
VLAN Support	Yes
QoS	Yes
Management	CLI, SNMP