TP-Link MC111CS - Switch

1.5.2 Switch
 TP_AUTO: The TP port operates in Auto-Negotiation mode;
 TP_DIS: The TP port operates in FORCE mode;
 TP_100M: The TP port operates in 100Base-Tx;
 TP_10M: The TP port operates in 10Base-T mode;
 TP_FDX: The TP port operates in Full-Duplex mode;
 TP_HDX: The TP port operates in Half-Duplex mode;
 LFP_OFF: The Link Fault Pass Through function is disabled;
 LFP_ON: The Link Fault Pass Through function is enabled.
Connect different devices, we suggest leaving the switches like these
as shown below, otherwise the Media Converter may not work
normally.
6