TP-Link SafeStream TL-ER6020 - Page 35

-30-
Choose the menu Network→LAN→DHCP to load the following page.
Figure 3-13 DHCP Settings
The following items are displayed on this screen:
 DHCP Settings
DHCP Server:
Enable or disable the DHCP server on your Router. To enable the
Router to assign the TCP/IP parameters to the computers in the LAN
automatically, please select Enable.
Start IP Address:
Enter the Start IP address to define a range for the DHCP server to
assign dynamic IP addresses. This address should be in the same IP
address subnet with the Router’s LAN IP address. The default
address is 192.168.0.2.
End IP Address:
Enter the End IP address to define a range for the DHCP server to
assign dynamic IP addresses. This address should be in the same IP
address subnet with the Router’s LAN IP address. The default
address is 192.168.0.254.
Lease Time:
Specify the length of time the DHCP server will reserve the IP address
for each computer. After the IP address expired, the client will be
automatically assigned a new one.
Default Gateway:
Optional. Enter the Gateway address to be assigned. It is
recommended to enter the IP address of the LAN port of the Router.
Default Domain:
Optional. Enter the domain name of your network.