TP-Link SafeStream TL-R600VPN - Hardware Installation Guide

SafeStream
TM
Gigabit Broadband VPN Router User GuideTL-R600VPN
Chapter 2. Hardware installation
2.1 Panel Layout
2.1.1 The Front Panel
The Router’s LEDs are located on the front panel (Viewed from left to right).
Figure 2-1
LED Descriptions:
Name Status Indication
Not lit The router is powered off.
PWR
Lit up (Green) The router is powered on.
Not lit The router has a hardware error.
Lit up (Green) The router has a hardware error.
SYS
Flashing
(Green)
The router works properly.
Not lit There is no device linked to the corresponding port.
Lit up
(Green/Yellow)
There is a device linked to the corresponding port but no
activity. (Green light indicates the linked device is running at
1000Mbps, and yellow indicates the linked device is running
at 10/100Mbps.)
WAN, LAN
Flashing
(Green/Yellow)
The corresponding port is transmitting or receiving data.
(Green light indicates the linked device is running at
1000Mbps, and yellow indicates the linked device is running
at 10/100Mbps.)
2.1.2 The Rear Panel
The rear panel contains the following features (Viewed from left to right).
Figure 2-2
¾ AC power receptacle: Connect the female of the power cord head here, and the male head
to the AC power outlet.
¾ RESET: Use the button to restore the router to the factory defaults.
There are two ways to reset the router:
2