TD-8817 ADSL2+ Ethernet/USB Modem Router User Guide
43
4.5.2.1. IP Filter
Select IP/
MAC Filter as the Filter type, and select IP as the Rule type (shown in Figure 4-36),
then you can configure the filter rules based on IP address. The filtering includes Outgoing and
Incoming, the detailed descriptions are provided below.
Figure 4-36
Filter Type Selection: Select the filter type for the configuration below.
IP/MAC Filter Set Index: Select the Set index for the IP Filter entry. This index can match
with six IP / MAC Filter Rule Indexes.
Interface: Select the interface for the entry.
Note:
If select PVC0~PVC7 as a interface, the filter will match the IP traffic of WAN port with specified
IPs (Source IP Address and Destination IP Address), If select LAN as a interface, the filter will
match the IP traffic of LAN port with specified IPs.
Direction: Select the direction for this IP Filter rule. There are three filtering directions: Both,
Incoming, Outgoing.
To Next Page
Loading...
