TP-Link TL-SF1024D User Manual

FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
CE Mark Warning
This is a class A product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures.
Note:
As for TL-SF1016DS, TL-SF1016, TL-SF1024D and TL-SF1024, a fuse
resistor is used in the “F1” position on the PCB of the power module. The fuse
resistor should be used with the following type: 10ohm 2W@25℃

TP-Link TL-SF1024D Specifications

General

Switching Capacity	4.8 Gbps
MAC Address Table	8K
Packet Forwarding Rate	3.57 Mpps
Power Supply	100-240VAC, 50/60Hz
Standards and Protocols	IEEE 802.3, IEEE 802.3u, IEEE 802.3x
Ports	24 10/100Mbps RJ45 ports
Jumbo Frame	Not supported

Summary

Product Introduction

Product Overview

Describes the general features and purpose of the switch model.

Features

Lists the technical specifications and capabilities of the switch.

Identifying External Components

Front Panel

Details the front panel layout, including switch model and LED indicators.

Rear Panel

Describes the rear panel components like power socket and grounding terminal.

Installation

Precautions

Outlines important safety and location requirements before installing the switch.

Desktop Installation

Provides step-by-step instructions for setting up the switch on a desk.

Rack Installation

Explains how to mount the switch securely in a standard 19-inch rack.

Connect to Ground

Details methods for grounding the switch for safety and lightning protection.

Power on

Guides on how to power on the switch and what LED indicators to expect.

Specifications

General

Lists general technical specifications of the switch, like standards and ports.

Environmental and Physical

Details the environmental operating conditions and physical dimensions.

Troubleshooting

Power LED Not Lit

Provides steps to diagnose why the power LED indicator is not illuminated.

Link/Act LED Not Lit

Offers solutions for when the Link/Act LED does not light up for a connected device.