Need help?Do you have a question about the TP-Link TL-SG1016 and is the answer not in the manual?
General| MAC address table | 8000 entries |
|---|---|
| Maximum data transfer rate | 2 Gbit/s |
| Supported data transfer rates | 10/100/1000 Mbps |
| 10G support | - |
| Full duplex | Yes |
| Networking standards | IEEE 802.3, IEEE 802.3ab, IEEE 802.3u, IEEE 802.3x |
| Dimensions (WxDxH) | 440 x 180 x 44 mm |
| Power requirements | 100 - 240V / 50-60Hz |
| Networking features | Gigabit Ethernet |
| Connectivity technology | Wired |
| Switch type | Unmanaged |
| Power connector | DC-in jack |
| Basic switching RJ-45 Ethernet ports quantity | 16 |
| Stackable | No |
| Certification | FCC, CE, RoHS |
| Product color | Brown |
| LED indicators | Status |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Storage relative humidity (H-H) | 5 - 90 % |
| Operating relative humidity (H-H) | 10 - 90 % |
Describes the high-performance, low-cost, easy-to-use features of the Gigabit Ethernet Switch for network upgrade.
Instructions on attaching rubber footpads and placing the switch on a desk, with notes on power and ventilation.
Details the process of mounting the switch in a standard 19-inch rack using "L" brackets and screws.
Explains how to power on the switch and what to expect from the LED indicators during initialization.
Describes the front panel of the TL-SG1024, including LED indicators and RJ-45 ports.
Details the rear panel of the TL-SG1024, which features the AC power receptacle.
Explains the Power, Link/Act, and 1000Mbps LED indicators and their meanings.
Covers general specifications like standards, topology, protocol, and data transfer rates.
Lists the types of LED indicators: Power, Link/Act, 1000Mbps.
Specifies the transfer method used by the switch as Store-and-Forward.
Describes the mechanism for MAC address learning as automatic learning and aging.
Details the frame filter rates for 10Base-T, 100Base-Tx, and 1000Base-T.
Details the frame forward rates for 10Base-T, 100Base-Tx, and 1000Base-T.
Covers physical dimensions, power supply, operating and storage conditions.
Provides steps to troubleshoot when the Power LED indicator is not lit.
Troubleshooting steps for Link/Act LED issues when a device is connected.
To Next Page