Need help?Do you have a question about the TP-Link TL-SG1048 and is the answer not in the manual?
General| Jumbo frames | 12000 |
|---|---|
| Forwarding rate | 71.4 Mpps |
| MAC address table | 16000 entries |
| Store-and-forward | Yes |
| Maximum data transfer rate | 1 Gbit/s |
| Supported data transfer rates | 10/100/1000 Mbps |
| 10G support | - |
| Networking standards | IEEE 802.3ab, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x |
| Copper ethernet cabling technology | 1000BASE-T, 100BASE-TX, 10BASE-T |
| Dimensions (WxDxH) | 440 x 360 x 44 mm |
| Connectivity technology | Wired |
| Dimensions (W x D x H) (imperial) | 17.3 x 14.2 x 1.7 \ |
| Switch type | Unmanaged |
| Supported network protocols | CSMA/CD, TCP/IP |
| Installed SFP modules quantity | 0 |
| Basic switching RJ-45 Ethernet ports type | Gigabit Ethernet (10/100/1000) |
| Basic switching RJ-45 Ethernet ports quantity | 48 |
| Form factor | 1U |
| Product color | Black |
| Compatible products | FCC, CE |
| Heat dissipation | 110.17 BTU/h |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Storage relative humidity (H-H) | 5 - 90 % |
| Operating relative humidity (H-H) | 10 - 90 % |
| Power source | AC |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (max) | 32.29 W |
| Package type | Box |
| Package depth | 336 mm |
| Package width | 528 mm |
| Package height | 100 mm |
| Harmonized System (HS) code | 85176990 |
Weight and Dimensions| Depth | 220 mm |
|---|---|
| Width | 440 mm |
| Height | 44 mm |
Lists the key features of the TL-SG1048, TL-SG1024, TL-SG1016, and TL-SG1008 series switches.
Provides essential safety rules for installation to prevent device damage and bodily injury, including grounding and power handling.
Provides step-by-step instructions for installing the switch on a desktop or in a standard 19-inch rack.
Explains requirements for outdoor and indoor cabling to minimize lightning damage, including burial, shielding, and distance rules.
Details methods for grounding the device, including connecting to a grounding bar or via the power supply's PE cable.
Describes the use of power and signal lightning arresters for surge protection against lightning strikes.
Describes the Power-On Self-Test (POST) process and LED indicator behavior after the switch is powered on.
Provides detailed technical specifications including standards, transmission medium, safety, protocol, and LED information.
To Next Page