User Guide 64
Configuring QoS Configuring Bandwidth Control
3
Configuring Bandwidth Control
Choose the menu QoS > Bandwidth Control to load the following page.
Figure 3-1 Configuring Bandwidth Control
Follow these steps to configure bandwidth control:
1) Select the desired ports and configure the ingress rate and egress rate for the ports.
Ingress Rate
(Kbps)
Configure the bandwidth for receiving packets on the port. If the rate for receiving
packets on the port exceeds the ingress rate, the packets will be discarded.
Egress Rate
(Kbps)
Configure the bandwidth for sending packets on the port. If the rate for sending
packets on the port exceeds the egress rate, the packets will be discarded.
2) Click Apply.
Note:
•
For a port, the ingress rate control feature and the storm control feature cannot be enabled
at the same time. If you enable ingress rate control for a port, storm control will be disabled
for that port automatically.
•
When egress rate is set for one or more ports, it is recommended to disable the flow control
on each port to ensure the switch works normally.
•
For ports in the same LAG, bandwidth control should be configured the same to ensure a
successful port aggregation.
To Next Page
Loading...
