TP-Link TL-SG3109 - Switch - Define Multicast Forward All Parameters

68
69
10.3 Dening Multicast Forward All Parameters
The Multicast Forward All Page contains elds for attaching ports or LAGs to a device that is attached to a neighboring
Multicast router/switch. Once IGMP Snooping is enabled, Multicast packets are forwarded to the appropriate port or VLAN.
Unless LAGs are dened, only a Multicast Forward All table displays.
To dene Multicast Forward All settings:
1. Click System > Bridging Cong > Multicast Support > Bridge Multicast > Multicast Forward All. The Multicast
Forward All Page opens:
Figure 99: Multicast Forward All Page
The Multicast Forward All Page contains the following
elds:
VLAN ID — Lists the VLAN for which Multicast
parameters are displayed.
Port/LAG — Ports that can be added to a Multicast
service.
The following table summarizes the Multicast settings which
can be assigned to ports, using the Multicast Forward All
Page.
Table 6: Bridge Multicast Forward All Router/Port Control Settings Table
Port Control Denition
D Attaches the port to the Multicast router or switch as a dynamic port.
S Attaches the port to the Multicast router or switch as a static port.
F Forbidden.
N The port is not attached to a Multicast router or switch.
2. Select a VLAN in the VLAN ID dropdown list.
3. Dene the VLAN port settings.
4. Click . The Multicast Forward All settings for the selected VLAN are dened and the device is updated.

