TP-Link TL-SG3109 - Configure the Multiple STP; Define MSTP Properties; Define Multicast Forward All Parameters

62
63
Point-to-Point Operational Status — Displays the point-to-point operating state.
LAG — Displays the LAG to which the interface is attached.
2. Click . The RSTP Settings Page opens:
Figure 88: RSTP Settings Page
The RSTP Settings Page contains the following fields in
addition to the settings listed in the RSTP Page:
Activate Protocol Migration — Indicates whether
sending Link Control Protocol (LCP) packets to
congure and test the data link is enabled. The possible
eld values are:
– Checked — Enables the Protocol Migration.
– Unchecked — Disables the Protocol Migration.
3. In the RSTP Settings Page, modify the following fields as required: Point-to-Point Admin Status, Point-to-Point
Operational Status.
4. Check the "Activate Protocol Migration Test" check box to activate Protocol Migration.
5. Click .
6. Click in the RSTP Page. The RSTP parameters are saved, and the device is updated.
9.3 Conguring the Multiple STP
Multiple Spanning Tree Protocol (MSTP) provides differing load balancing scenarios. For example, while port A is blocked in
one STP instance, the same port can be placed in the Forwarding state in another STP instance.
This section contains the following topics:
Dening MSTP Properties
Conguring MSTP Instances
Conguring MSTP VLAN Instances
Conguring MSTP Interface Settings
9.3.1 Dening MSTP Properties
The MSTP Properties Page contains information for dening global MSTP settings, including region names, MSTP revisions,
and maximum hops.
To dene MSTP:
1. Click System > Bridging Cong > Spanning Tree > MSTP > Properties. The MSTP Properties Page opens:






