St
atus: Select Enable/Disable the corresponding sampling entry.
11.3.2 Event Config
On this page, you can configure the RMON events.
Choose the menu SNMP→RMON→Event Config to load the following page.
Figure 11-10 Event Config
The following entries are displayed on this screen:
Event Table
Select: Select the desired entry for configuration.
Index: Displays the index number of the entry.
User: Enter the name of the User or the community to which the
event belongs.
Description: Give a description to the event for identification.
Type: Select the event type, which determines the act way of the
network device in response to an event.
None: No processing.
Log: Logging the event.
Notify: Sending trap messages to the management station.
Log&Notify: Logging the event and sending trap messages
to the management station.
Owner: Enter the name of the device or user that defined the entry.
Status: Select Enable/Disable the corresponding event entry.
11.3.3 Alarm Config
On this page, you can configure Statistic Group and Alarm Group for RMON.
Choose the menu SNMP→RMON→Alarm Config to load the following page.
136
To Next Page
Loading...
