Figure 4-6 Daylight Saving Time 
The following entries are displayed on this screen: 
  DST Config 
DST Status:  Enable or disable the DST. 
Predefined Mode:  Select a predefined DST configuration. 
  USA: Second Sunday in March, 02:00 ~ First Sunday in 
November, 02:00. 
  Australia: First Sunday in October, 02:00 ~ First Sunday in 
April, 03:00. 
  Europe: Last Sunday in March, 01:00 ~ Last Sunday in 
October, 01:00. 
  New Zealand: Last Sunday in September, 02:00 ~ First 
Sunday in April, 03:00. 
Recurring Mode:  Specify the DST configuration in recurring mode. This 
configuration is recurring in use. 
  Offset: Specify the time adding in minutes when Daylight 
Saving Time comes. 
  Start/End Time: Select starting time and ending time of 
Daylight Saving Time. 
Date Mode:  Specify the DST configuration in Date mode. This configuration is 
recurring in use. 
  Offset: Specify the time adding in minutes when Daylight 
Saving Time comes. 
  Start/End Time: Select starting time and ending time of 
Daylight Saving Time. 
Note: 
1.  When the DST is disabled, the predefined mode, recurring mode and date mode cannot be 
configured. 
2.  When the DST is enabled, the default daylight saving time is of Europe in predefined mode. 
15