TP-Link TL-SL3428 - Page 13

Chapter Introduction
Chapter 9 QoS This module is used to configure QoS function to provide different
quality of service for various network applications and
requirements. Here mainly introduces:
 DiffServ: Configure priorities, port priority, 802.1P priority and
DSCP priority.
 Bandwidth Control: Configure rate limit feature to control the
traffic rate on each port; configure storm control feature to filter
broadcast, multicast and UL frame in the network.
 Voice VLAN: Configure voice VLAN to transmit voice data
stream within the specified VLAN so as to ensure the
transmission priority of voice data stream and voice quality.
Chapter 10 ACL This module is used to configure match rules and process policies
of packets to filter packets in order to control the access of the
illegal users to the network. Here mainly introduces:
 Time-Range: Configure the effective time for ACL rules.
 ACL Config: ACL rules.
 Policy Config: Configure operation policies.
 Policy Binding: Bind the policy to a port/VLAN to take its effect on
a specific port/VLAN.
Chapter 11 Network Security This module is used to configure the multiple protection measures
for the network security. Here mainly introduces:
 IP-MAC Binding: Bind the IP address, MAC address, VLAN ID
and the connected Port number of the Host together.
 ARP Inspection: Configure ARP inspection feature to prevent the
network from ARP attacks.
 DoS Defend: Configure DoS defend feature to prevent DoS
attack.
 802.1X: Configure common access control mechanism for LAN
ports to solve mainly authentication and security problems.
Chapter 12 SNMP This module is used to configure SNMP function to provide a
management frame to monitor and maintain the network devices.
Here mainly introduces:
 SNMP Config: Configure global settings of SNMP function.
 Notification: Configure notification function for the management
station to monitor and process the events.
 RMON: Configure RMON function to monitor network more
efficiently.
Chapter 13 LLDP This module is used to configure LLDP function to provide
information for SNMP applications to simplify troubleshooting. Here
mainly introduces:
 Basic Config: Configure the LLDP parameters of the device.
 Device Info: View the LLDP information of the local device and its
neighbors.
 Device Statistics: View the LLDP statistics of the local device.
4