TP-Link TL-WA701ND Installation Guide

1
Connect to the Access Point with
the Ethernet cable or via wireless.
The default SSID of the Access
Point is TP-LINK_ XXXXXX. The
XXXXXX is the last 6 characters
of the Access Point’s MAC
address.
Plug the provided power adapter
into the power jack on the back of
the Access Point, and the other
end to a standard electrical wall
socket. Then press the ON/OFF
button to power on the device.
Turn on all of your network devices and then check to see if the LEDs on the
Access Point display normally as the diagram below describes.
Note
If the distance between the outlet and the Access Point is too long to supply
the power, you can refer to the Power over Ethernet (PoE) solution in
Appendix A: With PoE Setup on page 13.
Solid light
Flashing
Solid light or flashing
Flashing if the Wireless
Radio function is enabled

TP-Link TL-WA701ND Specifications

General

5 GHz	No
2.4 GHz	Yes
Modulation	16-QAM, 64-QAM, CCK, DBPSK, DQPSK, OFDM
Frequency band	2.4 - 2.4835 GHz
Maximum indoor range	30 m
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3u
Receiver sensitivity	135M: -69dBm@10% PER 54M: -73dBm@10% PER 11M: -85dBm@8% PER 6M: -89dBm@10% PER 1M: -90dBm@8% PER
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	150 Mbit/s
Placement	Table
Certification	RoHS, FCC
Product color	White
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %
Security algorithms	128-bit WEP, 152-bit WEP, 64-bit WEP, SSID, TKIP, WPA, WPA-PSK, WPA2, WPA2-PSK, WPS
Output current	0.6 A
Output voltage	9 V
USB 2.0 ports quantity	0
Ethernet LAN (RJ-45) ports	1
Antenna gain level (max)	5 dBi
Compatible operating systems	Windows 98SE, NT, 2000, XP, Vista, 7 MAC OS NetWare UNIX, Linux
Cables included	LAN (RJ-45)

Weight and Dimensions

Depth	125 mm
Width	181 mm
Height	36 mm