9
Chapter 2 Set Up Internet Connection
Note:
For more information about using WPS button on your host router, please refer to the router’s user
guide.
2. Wait until the RE LED changes from blinking to solid on, indicating successful
connection.
Note:
If the LED does not turn solid on, try again or refer to Method 1: Via the TP-Link Tether App or Method
3: Via a Web Browser.
3. The extender uses your router’s network name with _EXT at the end and shares the
same password as your router.
Extended Network Name:
Router’s network name with
_EXT
at the end
Password:
Same as your router’s
Note: If you want to customize the extended network name, refer to Configure Wireless Network.
4. Relocate your extender for optimal Wi-Fi coverage and performance.
3 ) Plug in the extender about halfway between your router and the Wi-Fi dead zone.
The location you choose must be within the range of the host network.
4 ) Wait for about 2 minutes until at least three Signal Strength LEDs turn solid on.
If not, relocate the extender closer to the router to achieve better signal quality.
Router Devices
Halfway
≥ 3 LEDs light up
Good
1
2
3
4
5
Best
Tips:
To minimize signal interference, please choose a location which is far away from Bluetooth devices and
other household electronic devices, such as cordless phones, microwave ovens and baby monitors.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
