5
Chapter 1
Get to Know About Your Extender
1. 2. 1. LED Explanation
You can check the extender’s working status by following the LED Explanation table.
Name Status Indication
RE
On/Off
The extender is connected or not connected to your router’s
wireless network.
Blinking WPS connection is in progress.
Wireless On/Off The extender’s wireless function is enabled or disabled.
Power
On/Off The extender is on or off.
Blinking The system is starting up or firmware upgrade is progress.
(Signal Strength)
On/Off
Indicates the Wi-Fi connection between the extender and the
router. More lit LEDs indicates a better signal strength.
Ethernet On/Off
The Ethernet port is connected or not connected to a powered-
on device.
1. 2. 2. Port and Button Description
Ports or Buttons Description
(WPS Button)
Press the WPS button on your host router, and immediately press the button
on the extender for 1 second. The RE LED of the extender should change from
blinking to solid on, indicating successful WPS connection.
RESET Button
With the extender powered on, use a pin to press the RESET button for 1
second. The extender will reset and reboot.
Ethernet Port
Connect your Ethernet-only device to the Ethernet port of the extender to join
the network.
Note: Make sure the device is being used within 0-40℃ and stored within -40-70℃.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
