2
English
Connect to the Access Point with the Ethernet cable or via wireless. The
default wireless network name (SSID) of the Access Point is
TP-LINK_AP_XXXXXX. Please check the label at the bottom of the unit for
more details.
Plug the provided power adapter into the power jack on the back of the
Access Point, and the other end to a standard electrical wall socket. Then
press the ON/OFF button to power on the device.
Connecting the Device for Configuration
Note
If the distance between the outlet and the Access Point is too long to supply
the power, you can refer to the Power over Ethernet (PoE) solution in
Appendix 1: With PoE Setup.
To Next Page
Loading...
