12
Access Point Mode
1. Set your wireless parameters. If desired, you may change your
Wireless Network Name, Wireless Security Mode, or Password.
Click Next and then Reboot.
Wireless Network Name(SSID):
TP-LINK_C5FC
(Also called the SSID)
Ensure you select a correct country to conform local law.
Incorrect settings may cause interference.
Region:
Warning:
Channel:
United States
Auto
Wireless Security Mode:
No Security
If you choose No Security mode, the wireless stations will be able to connect
the AP without encryption. It is recommened strongly that you choose one of
following options to enable security.
AP Mode setting:
NextBack
Working Mode Operation Mode
Wireless Setting Network Setting
Finish
Note: After the rebooting, reconnect to the network according to Instant
Wireless Connection.
Repeater/Client Mode
The examples illustrated below are from Repeater Mode, but the procedure is similar
for Client Mode.
1. Click Survey button to find the available wireless networks.
Then select the SSID of your target network and click Connect.
Wireless Name of Root AP
: (Also called the SSID)
Ensure you select a correct country to conform local law.
Incorrect settings may cause interference.
Region:
Warning:
Wireless Security Mode:
United States
Most Secure (WPA/WPA2-PSK
Wireless Password:
You can enter ASCII or Hexadecimal characters. For Hexadecimal, the length
should be between 8 and 64 characters; for ASCII, the length should be
between 8 and 63 characters. For good security it should be of ample length
and should not be a commonly known pharse.
Repaeter Mode setting:
NextBack
Working Mode Operation Mode
Wireless Setting Network Setting
Finish
MAC Address of Root AP:
WDS Mode:
Auto
All security settings, for example the wireless password should match the Root AP.
Survey
To Next Page
Loading...
