17
3
I cannot access Internet via my Cable Modem. What do I
do?
Reset the cable modem by powering it off, and then
powering it back on. Wait until its ONLINE LED is solid. Next,
unplug the TL-WR802N and plug it back in. This will allow you
to access Internet in most cases.
If the above does not work and you are unsure which mode
the TL-WR802N is in, please reset the TL-WR802N so that it
defaults back to Router Mode.
4
What can I do if my wireless keeps dropping?
By default, your wireless channel setting is set to “auto”. This
setting causes the TL-WR802N to select the least congested
channel between 1 and 11, allowing you to achieve the best
performance.
You may be experiencing frequent wireless drops due to
an often changing channel setting. In this case, setting your
wireless channel setting to a static channel between 1 and
11 will prevent the wireless frequency from changing, and
likely stabilize your network connection.
5
The TL-WR802N is on and I am connected, but I cannot
access the Web Management Page through my browser.
You need change your computer’s configuration settings to
“obtain an IP address automatically” and “obtain DNS server
address automatically.”
Please refer to the instructions below:
* For Windows 7:
> Go to Start -> Control Panel -> View network status and
tasks -> Change adapter settings.
> Right click Wireless Network Connection or Local Area
To Next Page
Loading...
