14
Chapter 3 Hardware Connection
Follow the steps below to complete the hardware connection.
*Only PoE NVRs have PoE ports to power PoE IPCs.
Monitor
Network Device
(e.g. Router, Switch)
or
Mouse
PoE IPCs
1. Connect your monitor to the HDMI or VGA port according to the
connection port it supports.
2.
C
onnect your monitor to a power source and turn it on.
3.
C
onnect the LAN port of the NVR to a network device with an Ethernet
cable.
4. Connect the provided USB Mouse to the USB Interface of the NVR.
Note:
■
If you want to turn off the NVR after installing the hard drive, right click on the
Live View screen and click the Power button on Main Menu of your monitor. Do
not unplug it directly.
■
The input voltage should match the power requirements of the NVR.
■
The buzzer on the NVR may be triggered when no hard drive is installed or
the hard drive in the NVR hasn’t been initialized. You can turn it off in Event-
Exception Detection-Disk Exception.
To Next Page
Loading...
