TP-Link WBS210 - Page 104

100
Go to the :LUHOHVV page. In the 0XOWL66,' section, Enable Multi-SSID. Click Add and
create a new wireless network.
SSID Specify the SSID of the wireless network.
VLAN Specify the VLAN to which the new wireless network belongs. The valid
value ranges from 1 to 4094.
SSID Broadcast Enable or disable SSID broadcast . With this feature enabled, the device
will broadcast the SSID.
AP Isolation Enable or disable AP Isolation. With this feature enabled, all the hosts
cannot communicate with each other.
Select the desired SSID and specify the Security.
SSID Select the desired SSID to specify the security settings.
Security Mode Specify the security mode for the desired SSID. The device only
supports WPA-PSK.