TP-Link WBS210 - Page 37

33
$3&OLHQW5RXWHU:,63&OLHQW
Follow the steps below to configure the device as AP Client Router (WISP Client) Mode:
Go to the 48,&.6(783 page, select
AP Client Router (WISP Client) and click Next .
Note:
The following window will pop up. Click Yes .
Note that if you select AP Client Router (WISP Client) as the operation mode, you will not access
the device through the WISP network after the process of quick setup. You can connect to the
port of the device or wirelessly to manage it. If you want to manage the device through the WISP
network, configure the Remote Login IP Address. For details, refer to
6.5. Configure Web Server .