82
Go to the 1HWZRUN page. In the 6WDWLF5RXWLQJ section, click
Add
and specify the
following parameters.
Enable Enable or disable the desired entry.
Target Network
IP
Enter the Target Network IP, the address of the network or host to be
visited. The IP address cannot be on the same network segment with the
device’s WAN or LAN port.
Netmask Specify the netmask for the desired entry.
Gateway IP Enter the Gateway IP, the address of the gateway that allows for contact
between the Device and the network or host
Click
Save
and click
Apply
, then click
Save
.
4.8 &RQILJXUH%DQGZLGWK&RQWURO
Note:
Bandwidth Control submenu is only available in AP Router Mode and AP Client Router (WISP Client)
Mode.
Bandwidth control function is used to control the internet bandwidth in the local area
network. In the case of insufficient bandwidth resources, enable the function to make the
device allocate reasonable bandwidth to the clients and achieve the purpose of efficient
use of the existing bandwidth. Via IP bandwidth control function, set the upper and lower
limit in the bandwidth of the computer network and guarantee a smooth sharing network.
To Next Page
Loading...
