T+A HA 200 - Troubleshooting

Troubleshooting
Device does not switch on
Cause 1:
Mains lead not plugged in correctly.
Remedy:
Check connection, push connector in rmly.
Cause 2:
Mains fuse burned out.
Remedy:
Have the mains fuse replaced by an authorised specialist workshop. The rating of the replacement fuse
must agree with the specication printed on the unit.
The device responds correctly to manual operation of the buttons on the front
panel, but does not respond to remote control commands
Cause:
The battery of the FM8 remote control is completely discharged.
Remedy:
Charge the FM8‘s built-in battery at the Charge socket on the back panel of the HA 200.
No audio les can be played from a Windows computer connected via USB
Cause:
For the playback via USB from a Windows PC drivers must be installed.
Remedy:
Download the driver package from the T+A homepage and install it as described in the installation
instructions.
One or more sources cannot be selected using the source selection buttons on
the device and the remote control.
Cause:
The source in question has been disabled.
Remedy:
Open the system settings menu and activate the deactivated source.
Many problems have a simple cause and a correspondingly simple solution. The following section describes a few
difculties you may encounter, and the measures you need to take to cure them. If you nd it impossible to solve
a problem with the help of these notes please disconnect the unit from the mains and ask your authorised T+A
specialist dealer for advice.
52