T+A PA 2000 R - Back Panel Connections

54
Back panel connections
IN 1 … IN 3
Universal pre-amplifier line inputs for connecting any stereo audio or TV equip-
ment fitted with symmetrical XLR outputs.

In the System Configuration menu it is possible to set input IN 3 (SRND) to
separate volume control for use with surround decoders. For more information
please see the chapter entitled ‘Surround operation with the PA 2000 R’.
IN 4 … IN 6
Universal pre-amplifier line inputs for connecting any stereo audio or TV equip-
ment fitted with asymmetrical RCA (Cinch) outputs.

In the System Configuration menu it is possible to set input IN 5 to separate
volume control for use with surround decoders. For more information please
see the chapter entitled ‘Surround operation with the PA 2000 R’.

Input IN 4 can be upgraded to form an input for an analogue turntable by fitting a
Phono MM or Phono MC module (optional accessories).
GND
Ground terminal
The ground lead from an analogue record player is connected here in order to
avoid hum.
PRE OUT
RCA (Cinch) pre-amplifier output for connecting external output stages or active
loudspeakers.

One pair of loudspeakers can be connected to the amplifier (SPEAKER  R
and SPEAKER  L). The impedance of each speaker must not be lower than
4  (DIN rating).

Caution!
Make sure that the terminals are firmly screwed down, and that no short-circuits
are possible as a result of projecting cable ends or errant wire strands.