Briefly press the -button on the front panel or long on the button on
the remote control handset to call up the menu.
When you open the menu, the following Select points appear on the screen:
Using the front-panel controls:
The volume knob is used to select any point within the menu system.
To change a selected menu item, press the volume knob to confirm your
choice, then adjust the value by rotating the knob.
After making the adjustment, press the volume knob again to adopt the new
setting.
You can interrupt the process at any time by pressing the button; in this
case any changes you have made are discarded.
Holding the volume knob pressed in takes you one level higher in the menu
system.
Press the button again to quit the menu.
Using the remote control handset:
Use the / buttons to select a item in the menu.
If you wish to change a selected menu item, first press the button,
and then use the / buttons to alter it.
After making the change, press the button again to accept the new
setting.
You can press the button at any time to interrupt the process; the
change is then abandoned.
Press the button again to leave the menu.
The purpose of this menu item is to define the method of connecting the
individual sources. When you call up the menu item, a list of inputs appears
together with the selected connection type. Set the connection to Cinch or XLR
in accordance with the method you have used to connect each source device.
The source IN 4 can also be switched to ‘SRND’ mode for use with surround
decoders. In this mode the volume and balance can be controlled separately for
the source IN 4.
At this menu item each source can be assigned a plain-text name which
appears in the screen displays.
Call up this menu item using the button, and you will see a list of all ex-
ternal sources connected to the PA 3000 HV. Each source is followed by the
displayed name in plain text.
To Next Page
Loading...
Need help?
General
