TRACE ELLIOT Transit B - Rear Panel Connections; Input Jack; Dry Out; DI Pre EQ XLR Output

6
Rear Panel
17 18 19 2015 16 21 22 23 24
(15) INPUT JACK
Accepts signal from the instrument cable.
(16) DRY OUT
Provides a buered version of the raw instrument signal to drive additional electronic inputs without loading
of the instrument. is is the only output that does not mute when the tuner is activated - allowing it to drive
an external tuner if preferred.
(17) AUX INPUT
Allows you to connect a media device to the unit and play along.
(18) HEADPHONE OUTPUT
1/8” headphone output for personal monitoring.
(19) DI PRE EQ XLR OUTPUT
e Transit B can be run with a signal source from either pre or post processing. Use this XLR output if the DI
is used in a live setting to send signal directly to a PA system. In this case, the DI signal will not be aected by
changing any of the preamp controls, which allows independent adjustments for the PA system. Output Level
Control (1) DOES NOT aect the output level of this output.
(20) DI POST EQ XLR OUTPUT
e POST EQ setting is useful for recording or connecting the preamp to an external power amplier in a live
application, or directly to a PA, if you want the on-board processing to be heard in the FOH system. Output
Level Control (1) DOES NOT aect the output level of this output.
(21) GND LIFT Switch
is switch may be used to eliminate hum caused by ground loops between the preamp and other equipment,
such as a mixing console.
(22)LINE OUTPUT
Line (high) level unbalanced output for driving the input of a power amp or an eects return.
(23)INST OUTPUT
Instrument (low) level unbalanced output for driving the input of a preamp or a mixer input channel.
(24) DC Input Socket
For connection of the included 9VDC power supply. Please note that the polarity of the center pin in the socket
is negative (-) with respect to ground. Please use the included Trace Elliot® Power Supply. Replacement Part
#000908180.