44
A diagnostic trouble code (DTC) will
flash on the LCD whenever an EFI
system error is detected. After 30 sec-
onds, the gauge will return to normal,
but the code will continue to flash
until the malfunction is corrected.
NOTE: Take the ATV to an autho-
rized dealer as soon as possible to
have the error corrected and the
system error reset.
2. Fuel Level Display — Shows the
approximate amount of gasoline in
the gas tank.
NOTE: When the fuel level indicator
flashes, approximately 3.5 L (0.92 U.S.
gal.) of gasoline remains in the tank.
3.
Mode Button — Press and release to
alternate between vehicle speed and
RPM. Press and hold to switch
between MPH and km/h.
4. Set/Reset Button — Press and release
to alternate between Odometer, Trip
1, Trip 2, Engine Hour Meter, and
Clock. Press and hold while Trip 1 or
Trip 2 are selected to clear the
selected trip data. The odometer can-
not be reset.
5.
Odometer/Trip Meter/Clock/Engine
Hour Meter Display — Shows total
distance the vehicle has traveled or
one of two trip meters used to mea-
sure trips or trip legs corresponding
to the vehicle speed function
selected (miles when MPH or kilo-
meters when km/h). The clock indi-
cates time in the 12-hour mode. The
engine hour meter indicates the total
time the vehicle’s engine has been
running and cannot be reset to zero.
To set the clock, use the following
procedure:
A. With the ignition switch ON, press
and release the Mode Button (3)
until the Clock/Engine Hour Meter
(1) is displayed; then (if necessary)
press and release the Set/Reset
Button (4) to the clock display.
B. Press and hold Set/Reset Button (4)
until minutes stop scrolling and the
hour display starts to scroll.
Momentarily release when correct
hour is displayed; then repeatedly
press and release Set/Reset Button
until correct minutes are displayed.
NOTE: Approximately two sec-
onds after releasing either Button,
the LCD will return to normal opera-
tion.
NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
“power-up” and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will “power-
up,” reset, and shut down repeat-
edly until clock memory power is
restored. Always check the 15-amp
accessory fuse if this gauge condi-
tion is noted.
NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
6. Gear Position Display — Shows
which gear is selected: L (low range)/
H (high range)/N (neutral)/R
(reverse)/P (park).
NOTE: An E will be displayed if
there is an error caused by a no-shift
position signal.
7. Engine Hour Meter Indicator — Indi-
cates engine hour meter mode is
selected on the display.
8. Speedometer/Tachometer Indicator
— Indicates which mode (MPH,
km/h, or RPM) is displayed.
9. 4WD Lock Indicator — Displays
LOCK when the front differential
lock has been engaged.
10. Drive Select Indicator — Displays
4WD when selected by the drive
select switch or when the 4WD Lock
is engaged. The display is blank when
in 2WD.
11. High Beam Indicator — Appears
when the headlights are on high
beam.
To Next Page
Loading...
