Tracker Off-Road 500S

Questions and Answers

L
leonardbrianAug 2, 2025
Why is the steering pulling to one side on my Tracker Off-Road 500S Offroad Vehicle?
- C
  Carrie DavisAug 2, 2025
  If your Tracker Off-Road vehicle's steering pulls to one side, it might be due to several reasons. The tires might be inflated unequally, so adjust the pressure. The front wheel alignment could be incorrect, so adjust the alignment. Also, worn or broken wheel hub bearings can cause this issue, so replace the bearings. A distorted frame can also be the cause, so repair or replace the frame. Finally, a defective shock absorber can lead to this problem, so replace the shock absorber.
R
Robert BrownAug 6, 2025
What to do if my Tracker Off-Road 500S has steering oscillation?
- C
  Cathy GrossAug 6, 2025
  If you experience steering oscillation in your Tracker Off-Road Offroad Vehicle, several factors could be responsible. It could be caused by tires inflated unequally, so adjust the pressure. Bent wheels can also cause this, so replace the wheel(s). Loose or missing wheel hub studs should be tightened or replaced. Worn or damaged wheel hub bearings should be replaced. Worn or loose tie rod ends should be replaced or tightened. Defective or incorrect tires should be replaced. Damaged A-arm bushings should be replaced. Loose bolts or nuts on the frame should be tightened.
R
Rachel BrownAug 10, 2025
Why does my Tracker Off-Road 500S Offroad Vehicle have rapid or uneven tire wear?
- K
  kyle82Aug 10, 2025
  If you notice rapid or uneven tire wear on your Tracker Off-Road Offroad Vehicle, it could be due to worn or loose wheel hub bearings, so replace the bearings. Incorrect front wheel alignment can also cause this issue, so adjust the alignment.
K
Kathryn GreenAug 15, 2025
How to fix steering noise on a Tracker Off-Road 500S Offroad Vehicle?
- C
  Charles ConleyAug 15, 2025
  If you are experiencing steering noise in your Tracker Off-Road Offroad Vehicle, check for loose cap screws or nuts and tighten them. Broken or damaged wheel hub bearings can also cause noise, so replace the bearings. Inadequate lubrication can be another cause, so lubricate the appropriate components.
C
Craig Lopez MDAug 18, 2025
How to fix handling that is too heavy or stiff on Tracker Off-Road Off-Road Vehicle?
- K
  Karen LeeAug 18, 2025
  If the steering feels too heavy or stiff on your Tracker Off-Road Offroad Vehicle, consider the following solutions: Adjust the alignment. Lubricate or replace the steering shaft. Adjust the pressure. Replace the tie rod ends.
M
Matthew PopeAug 23, 2025
What to do if the steering is impaired on my Tracker Off-Road 500S Offroad Vehicle?
- B
  Bruce LewisAug 23, 2025
  If the steering of your Tracker Off-Road Offroad Vehicle is impaired, it could be due to a few reasons. If the tire pressure is too high, adjust the pressure. If the steering linkage is worn, replace the linkage. If the cap screws in the suspension system are loose, tighten them.
L
Lauren HaynesAug 27, 2025
What causes rear wheel oscillation in a Tracker Off-Road Off-Road Vehicle?
- J
  Jorge LaneAug 27, 2025
  If you are experiencing rear wheel oscillation on your Tracker Off-Road Offroad Vehicle, there are several potential causes. Worn or loose rear wheel hub bearings can cause this, so replace the bearings. Defective or incorrect tires can also be a factor, so replace the tires. A distorted wheel rim should be replaced. Loose wheel hub cap screws should be tightened. Worn rear suspension arm-related bushings should be replaced. A damaged rear shock absorber should be replaced. Finally, a loose rear suspension arm nut should be tightened.