TU501-x
Short Guide TU501-x v4.2, May 2019, ©Trackunit 2019 14
Fuse
Recommended fuse holders and fuses for installation up to 48V supply
voltages (can be ordered at Trackunit A/S):
a. Supply voltage 12V/24V (Max 30A)
i. ATO blade fuses (Max 32V/1A) used with Littelfuse FHAC0002SXJ fuse
holder (standard).
ii. ATP blade fuse (Max 32V/1A - ATO style) used with TaiTek FH-
006WR-12R-12-U fuse holder (standard).
b. Supply voltage 12V - 48V (Max 30A)
i. FKS blade fuse (Max 80V/3A - ATO style) used with Littelfuse FH2 fuse
holder (recommended).
Machinery
The TU501 products comply with the essential requirements of the Directive
2006/42/EC and EU regulation 167/2013 when integrated as intended:
I. EN 13309 Construction machinery
II. ISO 13766 Earth-moving machinery
III. EN/ISO 14982 Agricultural and forestry machines.
IV. UN regulative ECE R10 EMC rev. 4 in accordance with EU regulation
661/2009 for Electronic Sub-Assembly (ESA).
NOTE: Harmonized standards under the directive 2014/30/EU have been
applied.
To Next Page
Loading...
