traegergrills.com
|
13
INITIAL FIRING INSTRUCTIONS
To be used on initial ring or anytime the grill runs out of pellets. In order to ensure
proper operation of the grill, you must rst prime the pellet hopper’s auger by allowing the auger
tube to be “charged” with pellets.
1
Remove the grill grate, cast-iron
griddle, and grease drip tray from
the inside of the grill.
2
With the Main Power switch in the
OFF (O) position, plug the power cord
into an appropriate grounded/earthed
electrical outlet. Once the grill is
plugged in, ip the Main Power
switch to ON (I).
3
Make sure there are no foreign objects
in the auger. With the grill in Idle
mode, press and hold the UP and
IGNITE buttons simultaneously. The
display will ash “Pri” and the auger
will begin priming.
4
Fill the hopper with your choice of
TRAEGER
®
BRAND HARDWOOD
PELLETS. The auger tube should take
approximately 2 minutes to ll with
pellets and begin dispensing into the
repot.
WARNING! Use ONLY TRAEGER
®
BRAND HARDWOOD PELLETS. Never
use heating fuel pellets in the grill.
NOTE: Once you turn on your grill, it will enter Idle mode,
and the display’s dashed border will pulse. This indicates
your grill is awaiting a command, and is not actively
operating. The grill MUST be in Idle mode to prime
the auger.
T01364_Ranger_OM_EN.indd 13 9/9/19 8:59 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
