traegergrills.com
|
15
INITIAL FIRING INSTRUCTIONS (cont.)
CONTROL SHUTDOWN CYCLE
The control for this grill comes with an automatic
shutdown cycle. When nished cooking on
your grill, press and hold the Center button for
3 seconds. The display will ash “OFF” for several
seconds, then scroll “COOL Dn” followed by the
actual temperature until the grill cools down to
a safe temperature.
While the controller is ashing “OFF,” you can
cancel the Shutdown Cycle by pressing and
holding the Center button for two seconds.
Always allow the Shutdown Cycle to completely
nish before powering off your grill at the Main
Power switch. The Shutdown Cycle ensures the
re is suppressed and the grill ignites properly
on the next use.
DANGER! Turning off the Main Power switch
will cut power to the grill components only.
When servicing the control or any other parts,
ensure that the power supply is disconnected
to avoid an electrical shock hazard.
SUBSEQUENT START-UP
1
With the Main Power switch set to ON (I),
press the Center button once to wake
the grill controller. Set the desired
temperature with the UP button.
2
Once the desired temperature is
displayed, press IGNITE. Allow grill
to preheat until desired temperature
is achieved.
NOTE: If the grill fails to achieve
the selected temperature, please see
“Operating Tips” on page 20 for more
information.
NOTES:
• Once you press the IGNITE button, your Traeger
®
Ranger Grill will always begin with an ignition
and preheat cycle.
• WARNING! When operating this grill, maintain a
minimum clearance of 18 in. (45.7 cm) from grill
to combustibles.
T01364_Ranger_OM_EN.indd 15 9/9/19 8:59 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
