traegergrills.com
|
23
Excess ash in the repot may cause your re
to go out. The repot should be inspected
occasionally and cleaned to remove the ash
buildup. Again, cleaning the ash from in and
around the repot should be done only when
the grill is COLD.
Remove the grill grate, griddle, and grease drip
tray to provide access to the repot and the
interior of the grill. Much of the ash outside of
the repot can be removed from the grill with a
small metal replace shovel or other similar tool.
WARNING! A dedicated vacuum cleaner is the
best way to remove ashes from the repot, but
this must be done with extreme care to avoid
the risk of re. Again, cleaning the ash from
the repot should be done only when the grill
is COLD.
A utility-type vacuum cleaner that has a metal
collection canister without a bag would be best
for this task. However, almost any vacuum
cleaner will work safely if this procedure is
properly followed.
After ensuring that the ash in the repot is
COLD, vacuum the ash from the inside of the
repot.
a. If your vacuum cleaner is a bagless model,
empty any previously accumulated debris
from the collection chamber. Then vacuum
the ashes from the inside of the repot.
Once the repot is clean, empty the
collection chamber into the metal container
described below without delay. Make sure
that there is no remaining ash residue left
in the collection chamber.
b. If your vacuum cleaner is a model
that uses a disposable bag, install
an unused bag in the machine. Then
vacuum the ashes from the inside of
the repot. Once the repot is clean,
remove the bag from the vacuum
cleaner and place it in the metal
container described below without
delay.
6. DISPOSAL OF ASHES:
WARNING! Ashes should be placed in a
metal container with a tight-tting lid. The
closed container of ashes should be placed
on a noncombustible oor or on the ground,
well away from all combustible materials,
pending nal disposal. When the ashes are
disposed of by burial in soil or otherwise
locally dispersed, they should be retained in
the closed container until all cinders have
cooled thoroughly.
7. If the supply cord is damaged, it must
be replaced by a special cord assembly
available from the manufacturer or its
service agent.
T01364_Ranger_OM_EN.indd 23 9/9/19 8:59 AM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
