15
TRAEGER.COM
SEASONING YOUR GRILL
TO BE USED ONLY DURING INITIAL FIRING. In order to ensure proper and safe operation of the grill, follow the instructions
below to prime the auger (“charge” the auger tube with pellets), season your grill, and run your grill at a high temperature (to burn o any
manufacturing oils).
1
Remove the grill grate and grease drip tray from the inside of the grill.
2
PLUG APPEARANCE MAY VARY BY REGION.
With the main power switch on the back of the grill hopper in the
OFF (O) position, plug the power cord into an appropriate grounded/
earthed GFCI electrical outlet.
Open the hopper lid. Make sure there are no foreign objects in
the auger before adding pellets to the hopper. Turn grill on: Flip
the main power switch on the back of the grill to ON (I). With the
grill in standby mode, press and hold the “Up” and IGNITE buttons
simultaneously. The display will flash “Pri” and the auger will begin
priming.
NOTE: When you turn on your grill, it
will automatically enter standby mode,
indicated by the display’s dashed
border pulsing. This indicates your
grill is awaiting a command, and is
not actively operating. The grill MUST be in standby mode to prime the
auger.
Afer adding pellets to the hopper, close the hopper lid. We
recommend you fill the hopper with pellets at least to the safety grate
in the hopper. Press the center button.
4
3
WARNING! GROUND FAULT CIRCUIT INTERRUPTER
(GFCI) PROTECTION MUST BE PROVIDED ON THE
CIRCUIT OR OUTLET USED TO POWER THE GRILL.
WARNING! USE ONLY TRAEGER® BRAND
HARDWOOD PELLETS, WHICH ARE SPECIFICALLY MADE
TO WORK IN OUR GRILLS. NEVER USE HEATING FUEL PELLETS
IN THE GRILL.
To Next Page
Loading...
