MSDS – CL83
Effective 9-14-2012
Page 2 of 5
4. FIRST AID MEASURES
EYE CONTACT: If this product contacts the eyes, immediately flush eyes with plenty of clean running
water for at least fifteen (15) minutes, lifting the upper and lower eyelids occasionally. Remove contact
lenses if worn. Seek medical attention.
SKIN CONTACT: If this product contacts the skin, immediately flush the affected area with soap and
water for at least fifteen (15) minutes. If the product penetrates the clothing and shoes, promptly remove
the contaminated clothing or shoes, and wash before reuse. Seek medical attention.
INGESTION: If this product is ingested, rinse the mouth with water. Give the exposed person one (1) to
two (2) glasses of water and seek medical attention promptly. Loosen tight clothing such as collar, tie,
belt or waistband. Do not induce vomiting unless directed differently by medical personnel. Never give
anything by mouth to an unconscious person. Seek medical attention.
INHALATION: If this product is inhaled and symptoms occur, move the exposed person to fresh air
promptly. Seek medical attention if symptoms persist. Seek medical attention.
NOTES TO PHYSICIAN: Treatment of overexposure should be directed at the control of symptoms and
the clinical condition of the patient.
5. FIRE FIGHTING MEAURES
FLASH POINT: None-aqueous solution.
FLAMMABLE LIMITS: NA
AUTOIGNITION TEMPERATURE: NA
EXTINGUISHING MEDIA: Use water, foam, dry chemical or carbon dioxide.
FIRE/EXPLOSION HAZARD: Not considered to be an explosion or fire hazard. Irritating smoke and toxic
vapors may be emitted during a fire.
FIRE FIGHTING EQUIPMENT: Fire fighters should wear full protective equipment, and have self-
contained breathing apparatus available.
SPECIAL PROCEDURES: Keep container cool with water spray.
HAZARDOUS COMBUSTION PRODUCTS: Not known.
6. ACCIDENTAL RELEASE MEASURES
PERSONAL PRECAUTIONS: Use proper personal protection (refer to Section 8).
ENVIRONMENTAL PRECAUTIONS: When possible, recover liquid as it may cause pollution. Keep out
of drains, municipal sewers, open bodies of water, and water courses.
CLEAN-UP METHODS: Safely stop the source of spill and clean up immediately. Wear protective
clothing and goggles. Dike the spill area and soak up material with sand or other absorbent material.
Place material into a chemical waste container for disposal according to local, state or federal regulations.
Flush the spill area with water.
To Next Page
Loading...
Need help?
General
