What causes loss of oil in Trane Chiller compressor?
Loss of oil in your Trane Chiller's compressor can be caused by: * Insufficient oil. Contact the Trane office before ordering oil. * A clogged filter drier. Replace the filter drier. * Liquid flowing back to the compressor. Adjust the superheat and check the bulb fixing of the expansion valve.
Why does my Trane AquaStream 2 CGWN compressor stop?
The compressor might stop due to the high pressure switch being tripped. This can be caused by several factors: * Discharge pressure being too high. * Voltage being too low. Contact your power supply utility. * Cooling demand being too high or the condensing temperature being too high. Refer to instructions for 'discharge pressure high'. * Insufficient cooling fluid. Repair the leak and add refrigerant. * Water flow to the evaporator being too low. Check the water flow rate and the flow switch contact in the water.
Why Trane Chiller compressor keeps running without stopping?
If your Trane Chiller's compressor runs continuously, it's likely due to: * Excess load on the cooling system. * Excess cooling demand on the system. In both cases, check the thermal insulation and air-tightness of the areas requiring air-conditioning.
What to do if Trane AquaStream 2 CGWN Chiller compressor stops just after starting?
If your Trane Chiller's compressor stops shortly after starting, it might be due to a clogged filter drier. Replace the filter drier to resolve this.
What to do if Trane AquaStream 2 CGWN Chiller compressor does not start up?
If the compressor on your Trane Chiller isn't starting, here's what you can check: * **Motor:** It may be burned out, requiring a compressor replacement. * **Coil/Contacts:** The coil might be burned out or the contacts broken, needing repair or replacement. * **Power:** There may be a power cut or the main power supply could be switched off. Check the fuses and connections. Determine why the system tripped. If operational, switch on the main power supply. * **Fuse:** A blown fuse could be the issue. Check the motor insulation and replace the fuse. * **Voltage:** Low voltage can prevent startup. Contact your power supply utility. * **Regulation Circuit:** An open regulation circuit could be the cause. Locate the regulation device that has tripped and investigate why. Consult t...
To Next Page
General