EasyManua.ls Logo

Trane CONQUEST CGAX 015 - Page 37

Trane CONQUEST CGAX 015
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CG-SVX027D-GB
37
11UNT-PRC002-GB
Sound power levels
Discharge
Measurement conditions:
Measurements taken in a room adjacent to the room containing the FWD, at the outlet of the rectangular duct (1.5 m
long) fixed to its discharge opening.
Fan Power level in dB(A), per Hz frequency band Overall power
Unit speed 125 250 500 1000 2000 4000 8000 dB(A)
1 55 50 42 37 37 31 30 46
FWD 08 2 57 54 47 40 30 38 40 50
3 58 57 50 42 32 40 43 53
1 57 51 45 42 34 33 28 48
FWD 10 2 58 54 48 45 38 39 35 51
3 60 58 50 48 40 42 39 54
1 57 51 45 42 34 33 28 48
FWD 12 2 58 54 48 45 38 39 35 51
3 60 58 50 48 40 42 39 54
1 56 62 50 48 39 38 36 56
FWD 14 2 61 66 55 53 47 46 45 60
3 63 69 58 56 50 50 49 63
1 57 63 51 49 40 39 37 57
FWD 20 2 61 66 55 53 47 46 45 60
3 63 69 58 56 50 50 49 63
Intake
Measurement conditions:
Measurements taken at the horizontal air intake.
Fan Power level in dB(A), per Hz frequency band Overall power
Unit speed 125 250 500 1000 2000 4000 8000 dB(A)
1 56 55 55 53 46 45 42 57
FWD 08 2 63 62 60 60 53 53 53 64
3 66 65 63 62 56 55 57 67
1 62 58 55 58 51 48 44 61
FWD 10 2 66 63 60 62 56 55 52 66
3 70 67 63 65 59 59 57 69
1 62 58 55 58 51 48 44 61
FWD 12 2 66 63 60 62 56 55 52 66
3 70 67 63 65 59 59 57 69
1 66 65 65 65 57 50 46 68
FWD 14 2 73 72 69 71 64 59 57 74
3 78 76 73 75 69 64 63 78
1 68 72 64 64 56 52 50 69
FWD 20 2 76 76 68 71 65 61 61 75
3 78 79 71 74 69 66 66 78
This section describes the overall operating principle of the CXAX design (Duplex Heating pump unit).
Figure 10 - Example of Typical Refrigerant System Schematic & Oil Lube Circuit Schematic
1: Scroll compressor
2: Evaporator (Brazed Plate Heat Exchanger)
3: Condenser (Fins and Tubes Heat Exchanger)
4: Heat Recovery (Brazed Plate Heat Exchanger)
5: Biflow Filter drier
6/TCE: Electronic Expansion Valve
7: Service Valve
8: Schrader Valve
9: Receiver
10: Four ways Reversing Valve
11: Suction/Liquid Heat Exchanger (Tube in Tube Exchanger)
PT: Pressure Transducer
PZH: High Pressure Switch
TT: Temperature Sensor
FSL: Flow Switch
UY: Solenoid
Note: Due to unit design there is no need to validate oil cycle while operating a reversible unit a long time in
cooling mode.
Operating Principles

Related product manuals