Service Settings (Non Password Protected Service Settings Group)
28 CVHE-CLD-1A
Evap/Cond Pump Off Delay Time
Range of values is 0 to 30 minutes in increments of 1
Minute. Factory Default is 1 Minute.
If the current running mode is hot water control state
the following display is substituted for the above
display:
Printer Setups
This screen is shown only when the Printer Option is
Installed.
If <Next> is pressed the following printer setup
screens are skipped. If <Enter> is pressed the
following screens are displayed to permit
modification of the printer setups.
The choices for Status are: Enable (Factory Default)
and Disable.
Range of values is 1 to 24 Hours in increments of 1
Hour. Factory Default is 8 Hours.
The choices for Status are: Enable (Factory Default)
and Disable.
Range of values is 1 to 5 in increments of 1. Factory
Default is 5.
Range of values is 2 to 120 seconds in increments of
1 second. Factory Default is 5 seconds.
The choices for Status are: 300, 1200, 2400, 4800,
9600 (Factory Default), and 19,200.
The choices for Status are: None (Factory Default),
Odd, and Even.
The choices for Status are: 8 (Factory Default) and 7.
The choices for Status are: 1 (Factory Default) and 2.
The choices for Status are: XON/XOFF (Factory
Default), DTR, RTS, and None.
Evap Pump Off Delay: xxx Min
Press (+)(-) to Change Setting
Cond Pump Off Delay: xxx Min
Press (+)(-) to Change Setting
Printer Setups
(Enter) to Change : (Next) to Continue
Print on Time Interval: [Status]
Press (+)(-) to Change Setting
Print Time Interval: xxx Hours
Press (+)(-) to Change Setting
Print on Diagnostic: [Status]
Press (+)(-) to Change Setting
Number of Pre-Diag Reports: xx
Press (+)(-) to Change Setting
Diagnostic Report Interval: xx sec
Press (+)(-) to Change Setting
Printer, Baud Rate: [Status]
Press (+)(-) to Change Setting
Printer, Parity: [Status]
Press (+)(-) to Change Setting
Printer, Data Bits: [Status]
Press (+)(-) to Change Setting
Printer, Stop Bits: [Status]
Press (+)(-) to Change Setting
Printer Handshaking: [Status]
Press (+)(-) to Change Setting
To Next Page
Loading...
Need help?
General
