Dynamic Set Point
Enabling the Dynamic Set Point and setting the appropriate parameters for the increase or decrease
of the set point and the range of outdoor temperatures in which this feature must be active, the Pa-
rameters table in under SD the controller will change the set point continuously according to a propor-
tional law.
With this function you can change the set point in order to ensure, to changing external conditions,
increased comfort or higher efficiency of the unit.
Below there is an example about the increase in efficiency achieved by enabling this function.
In the main screen, as for the Energy Saving, the will appear if this function is enabled.
The Dynamic Set Point is available only for air-water versions.
To Next Page
Loading...
