Unit Startup
46 RT-SVX46G-EN
• Program the Night Setback (NSB) panel (if applicable)
for proper unoccupied operation. Refer to the
programming instructions for the specific panel.
• Verify that the Remote panel “System” selection
sw
itch,
“Fan” selection switch, and “Zone
Temperature” settings for automatic operation are
correct.
• Inspect the unit for mispl
aced too
ls, hardware, and
debris.
• Verify that all exterior panels including the control
pa
nel
doors and condenser grilles are secured in place.
• Close the main disconnect switch or ci
rcuit protector
switch that provides the supply power to the unit’s
terminal block or the unit mounted disconnect switch.
To Next Page
Loading...
