Trane S9V2C100U5PSBC User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
March 2021
1188--CCEE1188DD11--11AA--EENN
Upflow/Horizontal and Dedicated Downflow
Gas-Fired, Direct/Non-Direct Vent, 2–Stage
Condensing Variable Speed Furnaces
UUppffllooww,, CCoonnvveerrttiibbllee ttoo
HHoorriizzoonnttaall RRiigghhtt oorr
HHoorriizzoonnttaall LLeefftt
S9V2B040U3PSBC
S9V2B060U4PSBC
S9V2B080U4PSBC
S9V2C080U5PSBC
S9V2C100U5PSBC
S9V2D120U5PSBC
DDoowwnnffllooww OOnnllyy
S9V2B040D3PSBC
S9V2B060D3PSBC
S9V2B080D4PSBC
S9V2C100D5PSBC
S9V2D120D5PSBC
NNoottee:: Graphics in this document are for
representation only. Actual
model may differ in appearance.
▲
CAUTION
!
COIL REQUIREMENT!
Failure to follow this Caution could result in property damage or personal injury. 4GXC* and
4MXC* coils installed on upflow furnaces in vertical, horizontal left, or horizontal right
orientations without a factory installed metal drain pan shield must use a MAY*FERCOLKITAA
kit. Coils installed on upflow furnaces must have drain pans that are suitable for 400° F
(205°C) or have a metal drain pan shield. Downflow furnaces do not require a metal drain pan
shield or the use of the MAY*FERCOLKITAA kit. See Installer’s Guide for more information.
18-CE18D1-1A-EN
Installer’s Guide

Trane S9V2C100U5PSBC Specifications

General

Model Number	S9V2C100U5PSBC
Brand	Trane
Category	Furnace
Heating Capacity	100, 000 BTU
Blower Type	Variable Speed
Type	Gas
Ignition Type	Hot Surface

Summary

Furnace Installation Guidelines

Safety Practices and Precautions

Essential safety practices and precautions for furnace installation, servicing, and operation.

General Installation Guidelines

Manufacturer's guidelines, code compliance, and handling of equipment during installation.

Locations and Clearances

Requirements for furnace placement, including clearances to combustible materials and specific locations.

Furnace Technical Drawings

Outline Drawings

Detailed outline drawings for Upflow and Downflow furnace cabinets (B, C, D sizes).

Furnace Installation Procedures

Gas Piping and Valve Adjustment

Instructions for gas piping connection, input check, and gas valve adjustment.

Venting and Airflow Requirements

Guidelines for venting, air for combustion, ventilation, and termination.

Duct Connections and Filters

Procedures for connecting ductwork and installing return air filters.

Electrical and Control System

Field Wiring and Thermostat Connections

Diagrams and instructions for thermostat and outdoor unit wiring.

Integrated Furnace Control (IFC) Operation

IFC menu structure, settings, display codes, and sequence of operation.

Fault Code Recovery and Defaults

Procedures for viewing, clearing, and resetting furnace fault codes and factory defaults.