SRUB-IOM001-EN 9
A
B
C
Installation
Lifting Recommendations
Before preparing the unit for lifting, estimate the approximate
center of gravity for lifting safety. Because of placement of
internal components, the unit weight may be unevenly
distributed.
Warning : On-sight lifting equipment must be capable of
lifting the unit weight with an adequate safety factor. The use
of under-capacity lifting devices may result in severe personal
injury or death and can seriously damage the unit.
The crated unit can be moved using a forklift of suitable
capacity. For lifting the unit, attach lifting straps or slings
securely to the lifting holes at each corner. Use spreader bars
to protect the unit casing from damage. Test lift the unit to
determine proper balance and stability.
Caution : Use spreader bars to prevent lifting straps from
damaging the unit. Install bars between lifting straps. This will
prevent the straps from crushing the unit cabinet or damaging
the unit finish.
Figure 1: Space Requirement for SRUB Model
Table 1: Show Space Requirement for SRUB Model
Inspection Checklist
To protect against loss due to damage incurred in transit,
complete the following checklist upon receipt of the unit.
Inspect individual pieces of the shipment before accepting
the unit. Check for obvious damage to the unit or packing
material.
Inspect the unit for concealed damage before it is stored
and as soon as possible after delivery. Concealed damage
must be reported within 15 days. If consealed damage is
discovered, stop unpacking the shipment. Do not remove
damaged material from the receiving location. Take
photos of the damage if possible. The owner must provide
reasonable evidence that the damage did not occur after
delivery.
Notify the carrier’s terminal of damage immediately by
phone and by mail. Request an immediate joint inspection
of the damage by the carrier and the consignee.
Notify the sales representative and arrange for repair.
Do not repair the unit until the damage is inspected by the
carrier’s representative.
Note : All dimension are inch
To Next Page
Loading...
