Trane TEM6A0B30H21SC User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
July 2022
1188--GGFF7744DD11--11RR--EENN
Convertible Air Handlers
2 — 5 Ton
TEM6A0B24H21SC
TEM6A0B30H21SC
TEM6A0C36H31SC
TEM6A0C42H41SC
TEM6A0C48H41SC
TEM6B0C60H51SA
The TEM6 series air handler is designed for installation in a closet,
utility room, alcove, basement, crawlspace or attic. These versatile
units are applicable to air conditioning and heat pump
applications. Several models are available to meet the specific
requirements of the outdoor equipment. Field installed electric
resistance heaters are available.
Installer’s Guide

Trane TEM6A0B30H21SC Specifications

General

Model Number	TEM6A0B30H21SC
Category	Air Handlers
Nominal Cooling Capacity	2.5 tons
Nominal Heating Capacity	30, 000 BTU/H
Voltage	208/230 V
Phase	1
Minimum Circuit Ampacity	15 A
Fan Motor Type	ECM
Airflow Range	600-1200 CFM
Width	22 in
Refrigerant	R-410A
Cabinet Construction	Metal
Fan Speed	Variable Speed

Summary

Safety Section

General Safety Warnings

Important warnings regarding electrical hazards, pressure, and sharp edges.

Installation and Operation Guide

Unit Installation Procedures

Steps for unpacking, location, ductwork, and condensate drain setup.

System Components and Setup

Details on refrigerant piping, blower, airflow, wiring, filters, and thermostat.

Operational Procedures and Maintenance

Covers system operation, checkout, and periodic maintenance requirements.

Field Wiring Diagrams

Single-Stage Wiring Configurations

Wiring for single-stage cooling-only and heat pump systems.

Two-Stage Wiring Configurations

Wiring for two-stage cooling-only and heat pump systems.

Electrical and Performance Data

Electrical Data and Heater Specifications

Electrical specifications and heater data for various model series.

Airflow Performance Charts

Cooling and heating airflow performance data across different models and settings.

Minimum Airflow CFM Requirements

Minimum required airflow CFM for various heater and system configurations.

Unit Specifications and Technical Data

Outline Drawing and Dimensions

Physical dimensions, clearances, and overall unit layout.

Heater Pressure Drop and Subcooling

Data on heater pressure drops and subcooling adjustment guidelines.

Coil Conversion Procedures

Downflow Configuration Conversion

Detailed steps to convert the coil for downflow installation.

Horizontal Right Configuration Conversion

Detailed steps to convert the coil for horizontal right installation.

Installation Checkout Procedures

Final Installation Checklist

A comprehensive checklist to ensure proper installation and system function.