Trane TEM6B0C60H51SA User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
July 2022
1188--GGFF7744DD11--11RR--EENN
Convertible Air Handlers
2 — 5 Ton
TEM6A0B24H21SC
TEM6A0B30H21SC
TEM6A0C36H31SC
TEM6A0C42H41SC
TEM6A0C48H41SC
TEM6B0C60H51SA
The TEM6 series air handler is designed for installation in a closet,
utility room, alcove, basement, crawlspace or attic. These versatile
units are applicable to air conditioning and heat pump
applications. Several models are available to meet the specific
requirements of the outdoor equipment. Field installed electric
resistance heaters are available.
Installer’s Guide

Trane TEM6B0C60H51SA Specifications

General

Model Number	TEM6B0C60H51SA
Category	Air Handlers
Nominal Cooling Capacity	5 tons
Airflow	Variable Speed
Heating Type	Electric
Voltage	208/230V
Phase	1
Maximum Fuse Size	60 amps
Cabinet	Galvanized Steel
Blower Type	Variable Speed
Width	21 inches
Depth	21 inches
Heating Capacity	60, 000 BTU
HSPF Rating	Up to 10 HSPF

Summary

Safety Section

General Safety Precautions

Critical warnings and cautions for electrical hazards, refrigerant pressure, sharp edges, vapors, and coil pressurization.

Installation Guide

Installation Instructions

Covers unpacking, unit location, ductwork, condensate drain, refrigerant piping, blower, wiring, thermostat, and maintenance.

Field Wiring

Illustrates connections for single/two-stage cooling and heat pump systems from thermostat to air handler.

Technical Data

Electrical and Performance Data

Details electrical specifications, airflow performance, and minimum CFM for various models and settings.

Outline Drawing and Dimensions

Presents physical dimensions, outline drawings, and minimum installation clearances for the unit.

Configuration and Conversion

Information on heater pressure drop, subcooling adjustments, and coil conversion for different installation orientations.

Checkout Procedures

Final System Verification

A checklist for final installation verification and system functional testing before handover.