Trane TEM6A0C36H31SC User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
July 2022
1188--GGFF7744DD11--11RR--EENN
Convertible Air Handlers
2 — 5 Ton
TEM6A0B24H21SC
TEM6A0B30H21SC
TEM6A0C36H31SC
TEM6A0C42H41SC
TEM6A0C48H41SC
TEM6B0C60H51SA
The TEM6 series air handler is designed for installation in a closet,
utility room, alcove, basement, crawlspace or attic. These versatile
units are applicable to air conditioning and heat pump
applications. Several models are available to meet the specific
requirements of the outdoor equipment. Field installed electric
resistance heaters are available.
Installer’s Guide

Trane TEM6A0C36H31SC Specifications

General

Model Number	TEM6A0C36H31SC
Category	Air Handlers
Refrigerant	R-410A
Nominal Airflow	1, 200 CFM
Voltage	208/230 V
Phase	1
Maximum External Static Pressure	0.8 in. WC
Cabinet	Galvanized Steel
Cooling Capacity	36000 BTU/H
Heating Capacity	36, 000 BTU/h
Blower Type	Multi-Speed
Blower Motor	Electronically Commutated Motor (ECM)

Summary

Convertible Air Handler Introduction

Initial Safety Warning

Only qualified personnel should install and service the equipment.

Comprehensive Safety Guidelines

Key Safety Advisories

Covers hazardous voltage, grounding, sharp edges, vapors, pressurized coils, and appliance usage.

Additional Safety Information

Child Safety and Chemical Exposure

Ensures children do not play with the appliance and warns of chemical exposure (lead).

System Configuration and Wiring

Wiring, Filter, Thermostat, and Cooling Sequence

Covers wiring requirements, filter selection, thermostat setup, and cooling operational sequence.

Heating and Defrost Operation

Heating Modes and Defrost Control

Explains heating modes (heat pump, electric) and defrost operation, including wiring for supplemental heat.

Post-Installation Procedures

Operational Checks and Maintenance

Field Wiring Diagrams

Single Stage Wiring

Field Wiring Diagrams: 2 Stage

2 Stage System Wiring

Electrical Data and Wiring Schematic

Control Box and Schematic Details

Presents a detailed wiring schematic and component overview for the control box and blower section.

Electrical Data: 24H/30H Heaters

Electrical Data: 36H/42SC Heaters

Electrical Data: 48H/60SA Heaters

Heater Electrical Specifications

Coil Conversion Instructions

Downflow Configuration Conversion

Coil Conversion Instructions: Horizontal Right

Horizontal Right Configuration Conversion

Checkout Procedures

Installation Verification Checklist

Lists essential checks for wiring, voltage, refrigerant lines, ductwork, and system function.