A
B
C
D
A
B
C
D
8 7 6 5 4 3 2 1
8 7 6 5 4 3 2 1
SIZE
DWG NO REV
TITLE
DRAWN DATE
THIRD ANGLE PROJECTION
D
REVISIONS
CHANGE NOTICE
REV DESCRIPTION DATE APPROVED
CODE IDENT NO
CHECKED
APPROVED
ENG APPVLFINISH
CAD GENERATED DRAWING,
DO NOT MANUALLY UPDATE
UNLESS OTHERWISE SPECIFIED TOLERANCES
ON DIMENSIONS PER TKS09109
SCALE 0.375 SHEET 1 OF 5
A
3E45668
DIAGRAM-BAR-LIFTING
--
--
--
08-May-19DC
THERMO KING IS THE SOLE OWNER OF THIS DRAWING
AND ALL INFORMATION IN IT, WHICH ARE PROTECTED
BY COPYRIGHT AND OTHER LAWS AND MAY BE SUBJECT
TO LAWS REGARDING EXPORTING INFORMATION
OUTSIDE OF THE U.S. THIS DRAWING MAY BE USED
ONLY BY ITS RECIPIENTS FOR THE PURPOSE FOR
WHICH IT IS PROVIDED AND ONLY BY THE RECIPIENT,
WHO AGREES THAT IT WILL NOT, WITHOUT THERMO
KING'S PRIOR WRITTEN PERMISSION: 1) DISCLOSE
NOR USE THIS DRAWING OR THE INFORMATION IN IT
EXCEPT AS SPECIFIED ABOVE; OR 2) MAKE ANY
COPIES OF OR EXTRACTS, REVISIONS, OR UPDATES
FROM THE DRAWING. ALL COPIES MUST BE RETURNED
TO THERMO KING UPON COMPLETION OF THE
WORK FOR WHICH THEY HAVE BEEN PROVIDED OR
UPON ANY EARLIER REQUEST.
NOTES:
1. USE THREE FORGED CLEVIS AND PINS TO ATTACH LIFTING CHAINS.
2. EACH ASSEMBLY MUST HAVE STRENGTH EQUAL TO MINIMUM OF 1.5 TIMES
THE WEIGHT OF THE HOIST AND MEET ALL SAFETY STANDARDS.
3. USE CENTER MEMBER LIFTING SLOT FOR MULTI TEMP UNITS,
USE REAR MEMBER SLOT FOR SINGLE TEMP UNITS.
4. SEAT LIFTING BOLT IN SLOT POSITION THAT LIFTS THE UNIT
AS BALANCED AS POSSIBLE.
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN INCHES.
INTERPRET DIM AND TOL PER
ASME T14.5M - 1994
REAR MEMBER
(SHEET 2)
CENTER MEMBER
(SHEET 4)
FRONT MEMBER
(SHEET 3)
SEE NOTES 3 & 4
SCALE 0.250
UNIT
TYPE
FRONT
CHAIN LIFT
HOLE LOCATION
ALL TS LEFT HOLE
ALL MD RIGHT HOLE
ALL KD & RD RIGHT HOLE
ALL T SERIES LEFT HOLE
2X
2X
To Next Page
Loading...
