Trane Thermo King T-590 Series - Page 43

TK 56700-1-IM-EN
43
Battery Connections
IImmppoorrttaanntt:: Safety precautions must be followed. Refer to BBaatttteerryy IInnssttaallllaattiioonn aanndd CCaabbllee RRoouuttiinngg HHaazzaarrddss located in
the SSaaffeettyy PPrreeccaauuttiioonnss section of this manual before proceeding.
NNoottee:: Thermo King units are designed for one 12 volt, group 31 battery. The battery must be suitable for deep cycling,
heavy duty, and rated with a minimum of 95 amp/hr.
IImmppoorrttaanntt:: Battery cables must be routed in split loom protective sleeving with no kinks or sharp bends.
Refer to the illustration on the following page for battery cable and fuse installation details.
PPoossiittiivvee CCaabbllee IInnssttaallllaattiioonn
1. At the unit, locate the large black cable marked PPOOSS++.
a. Route cable to battery, cut to proper length and add supplied battery cable lug.
b. DDOO NNOOTT connect to battery yet.
IInn--LLiinnee FFuussee IInnssttaallllaattiioonn
2. FOLLOW THE INSTALLATION INSTRUCTIONS (TK 56239).
FFuueell PPuummpp HHaarrnneessss IInnssttaallllaattiioonn
3. Route and connect the fuel pump harness to the fuel pump.
NNeeggaattiivvee CCaabbllee IInnssttaallllaattiioonn
4. At the unit, locate the large black cable marked NNEEGG..
a. Route cable to battery, cut to proper length and add battery lug from installation kit.
b. Connect cable to the NNEEGGAATTIIVVEE terminal of battery ((DDeettaaiill BB)).
5. All harnesses and battery cables should be neatly routed and secured with provided clamps.
6. Install battery box cover securely (if applicable).
NNaammeeppllaattee IInnssttaallllaattiioonn
7. Attach supplied nameplate near the battery the unit is connected to (vehicle’s battery or battery box).