EasyManua.ls Logo

Trane TR150 - Page 31

Trane TR150
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3.2.2 1-10 to 1-13 Motor Selection
NOTICE
This parameter group cannot be adjusted while the
motor is running.
The following parameters are active ('x') depending on the
setting of parameter 1-10 Motor Construction.
Parameter 1-10 Motor
Construction
[0]
Asynchron
[1] PM
Motor
non
salient
[2]
PM,
salient
IPM,
non-
Sat
[3]
PM,
salient
IPM,
Sat
Parameter 1-00 Congu-
ration Mode
xxxx
Parameter 1-03 Torque
Characteristics
x
Parameter 1-06 Clockwise
Direction
xxxx
Parameter 1-08 Motor
Control Bandwidth
xxxx
Parameter 1-14 Damping
Gain
xxx
Parameter 1-15 Low Speed
Filter Time Const.
xxx
Parameter 1-16 High Speed
Filter Time Const.
xxx
Parameter 1-17 Voltage lter
time const.
xxx
Parameter 1-20 Motor Power
[kW]
x
Parameter 1-22 Motor
Voltage
x
Parameter 1-23 Motor
Frequency
x
Parameter 1-24 Motor
Current
xxxx
Parameter 1-25 Motor
Nominal Speed
xxxx
Parameter 1-26 Motor Cont.
Rated Torque
xxx
Parameter 1-29 Automatic
Motor Adaption (AMA)
xxxx
Parameter 1-30 Stator
Resistance (Rs)
xxxx
Parameter 1-33 Stator
Leakage Reactance (X1)
x
Parameter 1-35 Main
Reactance (Xh)
x
Parameter 1-37 d-axis
Inductance (Ld)
xxx
Parameter 1-38 q-axis
Inductance (Lq)
xx
Parameter 1-10 Motor
Construction
[0]
Asynchron
[1] PM
Motor
non
salient
[2]
PM,
salient
IPM,
non-
Sat
[3]
PM,
salient
IPM,
Sat
Parameter 1-39 Motor Poles xxxx
Parameter 1-40 Back EMF at
1000 RPM
xxx
Parameter 1-42 Motor Cable
Length
xxxx
Parameter 1-43 Motor Cable
Length Feet
xxxx
Parameter 1-44 d-axis
Inductance Sat. (LdSat)
x
Parameter 1-45 q-axis
Inductance Sat. (LqSat)
x
Parameter 1-46 Position
Detection Gain
xxx
Parameter 1-48 Current at
Min Inductance for d-axis
x
Parameter 1-49 Current at
Min Inductance for q-axis
x
Parameter 1-50 Motor
Magnetisation at Zero Speed
x
Parameter 1-52 Min Speed
Normal Magnetising [Hz]
x
Parameter 1-55 U/f Charac-
teristic - U
x
Parameter 1-56 U/f Charac-
teristic - F
x
Parameter 1-62 Slip
Compensation
x
Parameter 1-63 Slip
Compensation Time
Constant
x
Parameter 1-64 Resonance
Dampening
x
Parameter 1-65 Resonance
Dampening Time Constant
x
Parameter 1-66 Min. Current
at Low Speed
xxx
Parameter 1-70 PM Start
Mode
xxx
Parameter 1-71 Start Delay xxxx
parameter 1-72 Start
Function
xxxx
Parameter 1-73 Flying Start xxxx
Parameter 1-80 Function at
Stop
xxxx
Parameter 1-90 Motor
Thermal Protection
xxxx
parameter 2-00 DC Hold
Current
xxxx
Parameters TR150 and TR170
30 02/2017 All rights reserved. BAS-SVP16B-EN
3
3

Table of Contents

Other manuals for Trane TR150

Related product manuals